Ford - Mountaineer - Parts Catalogue - 1997 - 2004

Mirror Removal Tool Form No. 529203 Operating Instructions CTAA585 dual end Ford Mirror Removal Tool CAUTION: To prevent personal injury, wear ANSI-compliant eye protection and gloves when using this tool. Application: 1997–’02 Windstar 1998–’04 Crown Victoria, Grand Marquis, Marauder, Taurus, Sable, Mustang, Town Car 1999–’04 Ranger; (Aero Mirror) Excursion, Super Crew (F-250 – F-550), F-650, F-750 2001–’04 Escape 2002–’04 Thunderbird 2. Disconnect heater wires from the glass, if so equipped. ~ 1. Tip mirror glass inboard, and use the Mirror Removal Tool to pry the outside lower glass edge from the motor assembly. Application: 1996–’04 Explorer 1997–’04 Mountaineer 1998–’04 Expedition, Navigator, F-150 1999–’04 E-Series (Areo Mirror) 2000–’04 LS 2001–’04 Explorer Sport, Explorer Sport Trac 2003–’04 Aviator 1. Tip the mirror glass assembly as shown to expose the glass-to-motor-assembly locking tabs. Use the Mirror Removal Tool to unlock the tabs. Pull the glass assembly from the motor assembly. 2. Disconnect heater wires from the glass, if so equipped. Application: 1998–’04 F-150 Heritage 1999–’04 (Dual Arm Mirror) Excursion, Super Crew (F-250 – F-550), F-650, F-750 1. Tip the mirror glass assembly as shown to expose the jackpins that connect the glass assembly. Use the Mirror Removal Tool to disconnect the jackpins. 2. Pull the glass assembly rearward, disconnecting the glass assembly socket from the motor assembly ball. 3. Disconnect heater wires from the glass, if so equipped. Note: When reassembling the glass, align the two jackpin ball keys to the mirror assembly slots. } } Mirror Removal Tool Jackpin © 2004 SPX Corporation Rev. B, April 13, 2005 Operating Instructions Ford Mirror Removal Tool CTAA585 Application: All FORD Inside Rear View Mirrors Refer to the appropriate vehicle service manual for more detailed instructions. Mirror Mount Figure 1 Removal 1. Remove the wire cover (if so equipped). 2. Unplug the connector (if so equipped). Insert tool from the top. 3. Remove the compass (if so equipped). 4. Refer to Figures 1 and 2, and determine which type of mirror mount is on the vehicle. 5. Insert the Mirror Removal Tool between the mirror mount and windshield bracket, from the top or bottom depending on the type of mirror mount. 6. Pry the mirror mount from the windshield bracket by pulling the tool away from the windshield. Mirror Mount Insert tool from the bottom. Figure 2 Installation 1. Slide the mirror mount over the windshield bracket from the top, and roll the mirror to the UP position. 2. Quickly press the mirror assembly downward along the windshield until the mirror mount is seated on the windshield bracket. See Figure 3. (Depending on the type of mirror mount, you may hear a “click” as the mount is seated into place on the windshield bracket.) 3. Reinstall the compass, electrical connector, and cover (if so equipped). Figure 3