Lexus - LS 600 - Workshop Manual - 2007 - 2007

LEXUS LS 460, LS 600hL 2007 - CARGO NET Preparation Part Number: PT347-50070 (DIO P/N) PT347-50075 (PPO P/N) Vehicle Service Parts (may be required for reassembly) Kit Contents Item # 1 2 Quantity Reqd. 1 1 NOTE: Part number of this accessory may not be the same as the part number shown. Description Convenience Net Installation Instructions Item # 1 2 3 Quantity Reqd. Description Hardware Bag Contents Item # 1 Quantity Reqd. Legend Description Additional Items Required For Installation Item # 1 Quantity Reqd. Description Conflicts Recommended Tools Personal & Vehicle Protection Notes STOP: Damage to the vehicle may occur. Do not proceed until process has been complied with. OPERATOR SAFETY: Use caution to avoid risk of injury. CAUTION: A process that must be carefully observed in order to reduce the risk of damage to the accessory/vehicle and to ensure a quality installation. TOOLS & EQUIPMENT: Used in Figures calls out the specific tools and equipment recommended for this process. REVISION MARK: This mark highlights a change in installation with respect to previous issue. None Special Tools Notes None Installation Tools Notes None Special Chemicals Notes None General Applicability Recommended Sequence of Application Item # 1 2 3 Accessory *Mandatory Issue: B 10/17/12 Page 1 of 4 pages LEXUS LS 460, LS460L, LS600hL 2007 - CARGO NET Procedure Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this accessory should follow approved guidelines to ensure a quality installation. These guidelines can be found in the "Accessory Installation Practices" document. This document covers such items as: Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.).  Safety (eye protection, rechecking torque procedure, etc.).  Vehicle Disassembly/Reassembly (panel removal, part storage, etc.).  Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.). Please see your Lexus dealer for a copy of this document. 1. Installation of Cargo Net. (a) Open trunk, locate anchor locations on the passenger’s side of the vehicle (Fig 1-1.) (b) Attach loop at the top of the net to the vehicle anchor as shown (Fig. 1-2). (c) Attach hook at the bottom of the net to the D-ring on the vehicle as shown (Fig. 1-3). Fig. 1-1 (d) Repeat steps 1(a) through 1(c) for the opposite side of the vehicle. Fig. 1-2 Fig. 1-3 Issue: B 10/17/12 Page 2 of 4 pages Supplier ref # 5INS060580TA LEXUS LS 460, LS460L, LS600hL 2007 - CARGO NET Procedure (e) Confirm completed assembly. Make sure net handle is facing out toward the rear of the vehicle (Fig. 1-4). Fig. 1-4 Issue: B 10/17/12 Page 3 of 4 pages Supplier ref # 5INS060580TA LEXUS LS 460 2007 - CARGO NET Checklist - these points MUST be checked to ensure a quality installation. Check: Look For: Accessory Function Checks Confirm that the net is attached properly to Make sure hooks are attached to floor the anchor points in the vehicle. D-rings and the loops are attached to the vehicle anchors at the top. The net handle should face out toward the rear of the vehicle. Issue: B 10/17/12 Page 4 of 4 pages Supplier ref # 5INS060580TA